Results 1 to 5 of 5

Thread: Dean Campbell's Christmas Bugger

  1. #1
    Join Date
    Jul 2006
    Posts
    55

    Default Dean Campbell's Christmas Bugger

    Would anybody happen to know the tying recipe for the Dean Campbell's Christmas Bugger? Also, the midge emerger and the v-rib midge?

  2. #2
    Join Date
    Feb 2006
    Location
    Knoxville
    Posts
    49

    Default Re: Dean Campbell's Christmas Bugger

    Hey 15yrold,

    The Christmas Bugger is tied this way:

    TMC 5202 streamer hook Sizes 6-10 (I like size
    Red tying thread
    Micro size lead barbell eyes
    Olive Grizzly Marabou for the tail
    LOOSELY dubbed, olive dyed squirrel fur for the body

    Tie in the eyes (on top of the hook shank) about 1/4 hook length behind the hook eye, then move to the hook bend and tie in the marabou tail. Wax up your thread and LOOSELY twist on the olive squirrel fur and wrap forward to the lead eyes. This thing needs to be bushy and ugly! Wrap the thread on past the eyes and build a good head up to the hook eye. Whip finish, dab on some cement, and you are done.

    This fly will ride hook point up since the eyes are tied on top of the hook shank, so don't be afraid to fish it in some tough places. I like to swing it on the upstream side of the "ledges" that are found on the Clinch and South Holston. You can get some nice fish that hang out under the lip of the ledge, but don't forget to fish the downstream side of the ledge also!

    Good Luck!
    Charles M.

  3. #3
    Join Date
    Feb 2006
    Location
    Knoxville
    Posts
    49

    Default Re: Dean Campbell's Christmas Bugger

    Oops, here are the recipes for the midge patterns:

    V-rib midge:

    Hook: TMC2487 or any scud style hook size 16-20
    Head: Gold brass bead head appropriate size for hook
    Thread: Should match body color (I prefer olive)
    Tail: None
    Body: Small size V-rib material (again, I prefer olive)

    Slide on bead head, tie in the v-rib material at the head, then wrap the thread over the v-rib half way down the hook bend. Sometimes it is useful to flatten the v-rib with needle nose pliers to make a slimmer body (just the part that will be overwrapped). Once you wrap the thread back to the stopping point, wrap it forward to the bead. Take the v-rib material and TIGHTLY wrap in forward to the bead. Tie it off and whip finish. The smaller the hook size, the tighter you should pull on the v-rib while wrapping it.
    I find it tough to go any lower than a size 20 hook.

    Midge Emerger:

    Hook: Size 20 (smaller if you dare)
    Thread: Gray, the thinner the better
    Wing Post: I use orange calf tail, but anything you can see and will still hold the hackle wraps
    Tail/Shuck: Gray antron, not too much
    Rib: Black sewing thread
    Body/thorax: Gray superfine dubbing
    Hackle: Grizzly or Medium Dun, sized to match hook

    Tie in the posting material just like any parachute fly. Move the thread back on the bend, tie in the shuck, then the rib, then dub a THIN body to the post. Wrap the rib forward and tie off at the post. Tie in the hackle on the post and wrap three times around, tie off and finish the head.

    When fishing this one, only apply floatant to the head and hackle. That way the shuck and the body will be under the surface film, just like the real thing. I've seen people tie and fish these down to a size 24, but my eyesight will allow neither! Some folks will tie this in olive also.

    Hope all this helps.


    Charles M.

  4. #4
    Join Date
    Jul 2006
    Posts
    55

    Default Re: Dean Campbell's Christmas Bugger

    For the midge emerger, what would be the best hackle color to use?

  5. #5
    Join Date
    Feb 2006
    Location
    Knoxville
    Posts
    49

    Default Re: Dean Campbell's Christmas Bugger

    15yrold,

    I think you can go either with grizzly or medium dun. I have had about the same success with both. Maybe the slight edge goes to grizzly, but if you don't have size 20 grizzly and do have size 20 medium dun, I wouldn't run out and buy the grizzly.

    If you opted to tie it as a BWO emerger, I would go with the dun.

    Proper presentation and a light tippet matter more in my opinion, especially when you start talking about flies size 20 and smaller.

    Best of luck to you.
    Charles M.

Similar Threads

  1. Troutfest 2012-Mike Adams-Dean Campbell
    By bigsur in forum Troutfest
    Replies: 3
    Last Post: 07-06-2012, 08:11 PM
  2. Ft Campbell KY
    By Streamhound in forum Fly Fishing for Trout in Other States
    Replies: 7
    Last Post: 04-21-2010, 10:51 AM
  3. Fort Campbell
    By silvercreek in forum Fly Fishing for Trout in Other States
    Replies: 4
    Last Post: 10-30-2009, 08:45 AM
  4. This is all Dean Campbell's fault
    By 92Esquire in forum Warmwater Fly Fishing
    Replies: 11
    Last Post: 10-03-2008, 08:08 PM
  5. Huge thanks to Dean Campbell!
    By 92Esquire in forum Warmwater Fly Fishing
    Replies: 7
    Last Post: 09-15-2008, 08:37 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •